RouteConverter Forum
Waypoints - wrong directions - Printable Version

+- RouteConverter Forum (https://forum.routeconverter.com)
+-- Forum: Users (https://forum.routeconverter.com/forum-17.html)
+--- Forum: English: Discussions (https://forum.routeconverter.com/forum-12.html)
+--- Thread: Waypoints - wrong directions (/thread-1945.html)



Waypoints - wrong directions - Stav - 13.11.2014

I have created a route with RouteConverter to use with OsmAnd. Most of the route works OK after a few corrections to remove a number of “back-tracking”. I am unable to correct the beginning of the route.
I have tried changing the waypoints positions, adding more waypoints , deleting some or even creating a new route. This odd behaviour means that the route cannot be followed unless the wrong directions are followed.

I don’t think it has to do with the RouteConverter but as I am quite inexperienced in this area I was wondering if you could suggest a solution

I am attaching (I hope I am :-) ) the section of the route that is creating this problem plus screenshots of wrong directions ( 4 images to show detail) and the way it should be.

( I couldn't insert images...)


=====================

RouteConverter - This is the correct route - only 3 waypoints. 1st is Worrelle Avenue and destination is Tongwell St

correct 1.png
correct 1.png   
===========

This is what OsmAnd creates.... arrows denote the direction

wrong.png
.gpx   worrelle 1.gpx (Size: 1.19 KB / Downloads: 1,004) Detail 1of3.png    Detail 2of3.png    Detail 3of3.png    correct 1.png   
Detail 1of3.png
Detail 2of3.png
Detail 3of3.png

Many Thanks


RE: Waypoints - wrong directions - routeconverter - 17.11.2014

(13.11.2014, 09:24)Stav Wrote: I don’t think it has to do with the RouteConverter but as I am quite inexperienced in this area I was wondering if you could suggest a solution

Have you've read the route planning page?


RE: Waypoints - wrong directions - Stav - 17.11.2014

Hi Christian

Yes I have read the route planning page and tried different waypoint positions and numbers but no luck. I am convinced is the OsmAnd algorithm the culprit. I have posted the issue to the OsmAnd forum but I had no response from any of their developers yet ...... and possibly never will

Thanks for responding

Regards