20.08.2008, 16:37
(This post was last modified: 20.08.2008, 16:38 by motorgekske.)
kostermw Wrote:The filter option is a miracle to use. Very smart. There's one thing I have a problem with, and that is repositioning (editing) points which were (most likely) incorrectly recorded, and are off-road. If I select a point I can move it to a new location. However, the line attached to it remains at it's position. Hence, the point is not realy moving, because when you click it again from the list, it is in the old position.
Are you planning to enhance functionality so you can move points?
Hello Christian and kostermw,
I noticed the same behaviour when I upgraded from version 1.19 to 1.20 this morning. And if you add a NEW routepoint this has the same behaviour. I've read through the discussion and would like to start with answering the questions of Christian. I am using XP SP3 with firewall disabled, but I have a hardware firewall in my LAN which is setup to allow ALL outgoing traffic. I'm also using Mc Afee Virusscan without firewall option. I created an exeption in Mc Afee 's "Unwanted Programms Policy" to exclude "IeEmbed.exe" and until now it looks like it's working again. Maybe this could be a solution for you too. Regards, Motorgekske.
Keep up the good work Christian.