11.07.2016, 21:12
Hi
First of all thanks for such a useful piece of software - it's one of my go-to programs.
Not sure if this is the right place to report a bug but here goes: I have my preferences set to statute. I loaded a track containing elevaton in metres, these were displayed correctly in feet. However when I then applied auto-complete to elevations, RC read the elevations - in metres - from the data source and applied them *without* converting; so 2306ft (703m in the original file) became 786ft instead of 786m.
I'm on v2.17 BTW.
If I could bolt on a feature rquest as well, it would be great if the units for elevation could be selected independently of the units for distance, as I generally want to see distance in miles and elevation in metres.
Thanks
First of all thanks for such a useful piece of software - it's one of my go-to programs.
Not sure if this is the right place to report a bug but here goes: I have my preferences set to statute. I loaded a track containing elevaton in metres, these were displayed correctly in feet. However when I then applied auto-complete to elevations, RC read the elevations - in metres - from the data source and applied them *without* converting; so 2306ft (703m in the original file) became 786ft instead of 786m.
I'm on v2.17 BTW.
If I could bolt on a feature rquest as well, it would be great if the units for elevation could be selected independently of the units for distance, as I generally want to see distance in miles and elevation in metres.
Thanks