Hi Christian,
i have reviewed the PRE version. Maybe we have a misunderstanding. I can switch the map positioning as you can see pics 7 to 11.
But then the offset in the track which I copied from external source is still there. (Google mymaps -> exp. KML -> into Google earth -> copy Google earth track info -> into Routeconverter) .
Thats why I would need a way to either shift the whole track by dragging to correct satellite position or have a window where i can input a figure X & Y which will be used to recalculate the coordinates to correct values so that the track is finally at real position in satellite map (see the red dots in pic 11, the track should shift to the crossroad)
When I just load the KML directly into routeconverter it has only two points and a route is calculated. But this calculation misses a lot of small road information that exist in the google routing.
That is the reason why I import the thousands of track points.
I sent a test GPX file with two tracks, 1 taken unmodified from Google, 1 that I have recalulated. You can see that the coordinates of points with same number have changed. (I used point 59 & 60 as references for calculation)
Regards
Shuben
PS: my response might take a while as I am out next few days.
i have reviewed the PRE version. Maybe we have a misunderstanding. I can switch the map positioning as you can see pics 7 to 11.
But then the offset in the track which I copied from external source is still there. (Google mymaps -> exp. KML -> into Google earth -> copy Google earth track info -> into Routeconverter) .
Thats why I would need a way to either shift the whole track by dragging to correct satellite position or have a window where i can input a figure X & Y which will be used to recalculate the coordinates to correct values so that the track is finally at real position in satellite map (see the red dots in pic 11, the track should shift to the crossroad)
When I just load the KML directly into routeconverter it has only two points and a route is calculated. But this calculation misses a lot of small road information that exist in the google routing.
That is the reason why I import the thousands of track points.
I sent a test GPX file with two tracks, 1 taken unmodified from Google, 1 that I have recalulated. You can see that the coordinates of points with same number have changed. (I used point 59 & 60 as references for calculation)
Regards
Shuben
PS: my response might take a while as I am out next few days.