28.08.2009, 16:07
If I zoom in all the way on a route and delete one point the map stays zoomed in all the way and the area I am working on stays where I have it in my display. If, however, I select several points all around that one point, which are junk because the car was parked at that spot, but passing traffic caused spurious points to appear, and delete all of those points as a selected group, the map zooms back out to the starting magnification, and I have to zoom all the way in again. I HATE that extra step, over and over, as I get rid of the junk in a file when I have made a number of stops during the course of my local travels. I would much prefer the program to stay zoomed all the way in whether I remove one point or a bunch of points from the track. That way I control where I am looking in the file by simply clicking on a point in the listing on the right side of the screen, and then looking at that area of the total track to see if I need to delete one or more such points. Usually, with the GT-120, it is three or four points for each jog of the car due to a passing truck or bus, or whatever causes the unit to think it has moved. The ASUS R300 is less prone to that but still will jump to the right or left when I stop for a traffic light, so there too I might need to remove two or three consecutive points, and again the image zooms out again and thus once more I need to zoom in all the way. HELP!!!! In my view this is [!%!^@#&#$^]