13.09.2009, 20:13
The S&T2010 export of a GPX file only exports the LAT and LONG for each rtept, and not the date and time. However if it is working from an imported GPX file from a different source, such as my ASUS R300, it retains each second's point and does not remove duplicates so an stop for a minute shows 60 identical positions in a row. What I need is a way to quickly see those via the SPEED column. The Speed cannot be calculated since there is no date and time information, and while when I use the ASUS R300 the interval is 1 second, if I use my GT-120 from Mobile Action, the interval can be 1 second, 2 seconds or 30 seconds, since I can set that value in that unit. So what I would like, when there is NO way to calculate speed, is a way to see if the vehicle was moving at that point in time, which RouteConverter CAN determine, since the lat and/or long are changing when it is moving, and remain the same when it is not moving. For all I care, it could be a + when the car is moving, and nothing when the car is not moving. I just want to be able to see the stops in the view on the left side of the screen, so I can look up what was at that location, without having to also load the original GPX file and try to have two separate images open. Is that possible? The other alternative is to allow me to state an interval between points so that RouteConverter can calculate the speed, since the date is NOT important for that bit of math.