Annoying change of map area

[routeconverter]

Why does the map pane reset to view the whole track when I toggle between track/waypointlist/route?

Since a track is something different than a waypoint list or a route I'm using different ways to display them. Not removing them when you change the characteristics of the position list seems ridiculous to me.

Is there a was to configure RouteConverter so that is doesn't update which area of the map that is being viewed (only redraw the track/waypoint list/route)?

That's what a lot of code inside RouteConverter is about: reducing the amount of effort required to update the map.

But what is your real problem? Is RouteConverter too slow for you?