I have now completed the cruise and have lots of GPX files where the path has deviated from the actual road due to tall buildings, too many waves while at sea, and just unaccounted for jumps to the left or right of the actual path the ship, bus, taxi or walker took. I want to eliminate spurious points at the start and end of each GPX file, where the ship was not yet moving, or while I was sitting down in place with the I-GotU recording puck in my pocket. However that leaves the points during the excursion where I need to move the point back to the road, or slightly off the road for a stop, or otherwise shift the point. When i do that with an existing point I want to KEEP the date and time already assigned to that point. However Routeconverter removes the date and time, forcing me to manually put it back, since I then use the corrected file for geocoding my photographs. That, in fact, is the reason behind the GPX files in the first place, and without the date and time in the GPX file the whole is useless for doing any geocoding.
HELP... I need a way to KEEP the date and time for each point, even when I manually shift them. I can always then adjust the time slightly if it is appropriate, without also having to reenter the date as well. I am looking to retain my data and reduce the manual key entry of data that was IN the file when I started.
RsH
HELP... I need a way to KEEP the date and time for each point, even when I manually shift them. I can always then adjust the time slightly if it is appropriate, without also having to reenter the date as well. I am looking to retain my data and reduce the manual key entry of data that was IN the file when I started.
RsH