I have created a route with RouteConverter to use with OsmAnd. Most of the route works OK after a few corrections to remove a number of “back-tracking”. I am unable to correct the beginning of the route.
I have tried changing the waypoints positions, adding more waypoints , deleting some or even creating a new route. This odd behaviour means that the route cannot be followed unless the wrong directions are followed.
I don’t think it has to do with the RouteConverter but as I am quite inexperienced in this area I was wondering if you could suggest a solution
I am attaching (I hope I am :-) ) the section of the route that is creating this problem plus screenshots of wrong directions ( 4 images to show detail) and the way it should be.
( I couldn't insert images...)
=====================
RouteConverter - This is the correct route - only 3 waypoints. 1st is Worrelle Avenue and destination is Tongwell St
correct 1.png
===========
This is what OsmAnd creates.... arrows denote the direction
wrong.png
worrelle 1.gpx (Size: 1.19 KB / Downloads: 842)
Detail 1of3.png
Detail 2of3.png
Detail 3of3.png
Many Thanks
I have tried changing the waypoints positions, adding more waypoints , deleting some or even creating a new route. This odd behaviour means that the route cannot be followed unless the wrong directions are followed.
I don’t think it has to do with the RouteConverter but as I am quite inexperienced in this area I was wondering if you could suggest a solution
I am attaching (I hope I am :-) ) the section of the route that is creating this problem plus screenshots of wrong directions ( 4 images to show detail) and the way it should be.
( I couldn't insert images...)
=====================
RouteConverter - This is the correct route - only 3 waypoints. 1st is Worrelle Avenue and destination is Tongwell St
correct 1.png
===========
This is what OsmAnd creates.... arrows denote the direction
wrong.png
worrelle 1.gpx (Size: 1.19 KB / Downloads: 842)
Detail 1of3.png
Detail 2of3.png
Detail 3of3.png
Many Thanks